Put a thin coating of sealer compound on threads (1) of temperature trans-
Using 15/16-inch wrench, screw in and tighten temperature transmitter (2)
into hole in intake manifold (3).
Plug connector (4) into temperature transmitter.
Follow-on Maintenance Action Required:
Fill cooling system. Refer to para 6-10.
Check that operation of water temperature gage.
Refer to TM 9-2320-209-10.
Check temperature transmitter for leaks.
Close hood and right side panel. Refer to
Reconnect battery ground cable. Refer to para 7-58.
END OF TASK