ALTERNATOR AND PULLEY REMOVAL AND REPLACEMENT - continued

TM 9-2320-209-20-3-1

FRAME 6

CAUTION

Be careful when putting positive cable terminal lug (1)

on terminal (2). This cable goes to the battery. The

lug is larger and more rounded on one side. This side

must go up. Putting lug on the wrong way could short

out the alternator and damage it.

Put positive cable terminal lug (1) on terminal (2) as shown. Put lockwasher

(3) on terminal and screw on nut (4). Using torque wrench, tighten nut to

45 to 55 pound-inches.

Put ground cable terminal lug (5) over hole in terminal block (6) as shown.

Put lockwasher (7) on bolt (8) and put bolt through terminal lug.

Screw bolt (8) into terminal block (6), and using torque wrench, tighten bolt

to 82 to 102 pound-inches.

GO TO FRAME 7

7-25