 |
|||
|
|
|||
|
Page Title:
ENGINE STOP CONTROLS AND LINKAGES REMOVAL, REPAIR, REPLACEMENT, AND ADJUSTMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
e.
Adjustment.
I
FRAME 1
Push ENGINE STOP control (1) all the way in.
1.
Pull fuel shutoff valve actuator (2) all the way out (toward firewall).
2.
3.
Slide control cable (3) in clamp (4) so that end of control cable clears fuel
shutoff valve actuator ( 2) by no less than 1/2inch.
Using 11/32-inch wrench and screwdriver, tighten nut (5) on screw ( 6). Push
4.
fuel shutoff valve actuator (2) all the way in.
Make sure control wire (7) passes through hole in swivel (8) as shown. Using
5.
screwdriver, tighten screw (9). Bend end of control wire up.
Move ENGINE STOP control (1) out and in several times.
6.
Check that fuel shutoff valve actuator (2) and control linkage move smoothly
7.
without binding.
NOTE
Follow-on Maintenance Action Required:
1.
Close hood and left side panel. Refer to TM 9-2320-209-10.
2.
Replace light switch. Refer to para 7-14.
END OF TASK
TA
047404
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version