 |
|||
|
|
|||
|
Page Title:
ACCELERATOR CONTROLS AND LINKAGES REMOVAL, REPAIR, REPLACEMENT, AND ADJUSTMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
Adjustment.
e.
FRAME 1
Using l/2-inch wrench, unscrew and take off locknut (1) from threaded stud
1.
on ball joint (2).
2.
Take ball joint (2) out of lever assembly (3).
Using 1/2-inch wrench, loosen nut (4).
3.
Shorten rod (5) by screwing ball joint (2) onto rod.
4.
5.
Lengthen rod (5) by unscrewing ball joint (2).
When length of rod (5) is correct, threaded stud on ball joint (2) will slide
6.
into lever assembly (3) freely. Put threaded stud of ball joint (2) through
hole in lever assembly (3) and using 1/2-inch wrench, tighten nut (4).
Using 1/2-inch wrench, screw locknut (1) on threaded stud of ball joint (2).
7.
END OF TASK
TA 047152
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version