Screw on and hand tighten nozzle and valve assembly (1) until there is
l/2-inch clearance between nozzle and valve assembly and housing (2).
Using l-inch wrench tighten jamnut (3).
Using 7/16-inch 6-point socket, screw in and tighten inlet adapter (4).
Using 3/8-inch wrench, screw on and tighten tube adapter (5) with tube (6).
Using 7/16-inch wrench, screw on and tighten tube adapter (7) with tube (8).
Put fuel from container in approved disposal area.
Follow-on Maintenance Action Required:
Close hood and right side panel. Refer to TM 9-2320-209-10.
END OF TASK