Put cover (l) over four studs (2) and seat cover firmly on gasket (3).
Some pumps use three studs (2) to mount terminal cover(l).
Put four lockwashers (4) onstuds (2) and screw on four nuts (5). Using wrench,
Thread end of wire on metallic seal (6) through hole in end of one stud (2). Thread
end of wire back into metallic seal and squeeze seal using lead seal press.
Join connector (7) to receptacle (8).
Follow-on Maintenance Action Required:
Start truck and let engine run. Refer to TM 9-2320-209-10.
END OF TASK