c. Repair. Repair clutch control and linkages by welding, straightening or
replacing any broken or damaged parts. Refer to TM 9-237.
Put pedal lever shaft (1) through brake lever assembly (2) and then through
shaft support ( 3) as shown.
Put woodruff key (4) in slot at end of pedal lever shaft ( 1).
Put control lever (5) on end of pedal lever shaft (1) . Pedal lever slot must
aline with key (4) on shaft. End of control lever should be flush with shaft.
Using 9/16-inch wrenches, tighten locknut (6) while holding bolt ( 7).
GO TO FRAME 2