Chapter 3. CLUTCH SYSTEM GROUP MAINTENANCE

TM 9-2320-209-20-3-1

CLUTCH SYSTEM GROUP MAINTENANCE

Section I. SCOPE

3-1. EQUIPMENT ITEMS COVERED. This chapter gives equipment maintenance pro-

cedures for the clutch linkage assembly for which there are authorized corrective

maintenance tasks at the organizational maintenance level.

3-2. EQUIPMENT ITEMS NOT COVERED . All equipment items for which corrective

maintenance is authorized at the organizational maintenance level are covered in this

chapter.

Section II.

CLUTCH

LINKAGE

ASSEMBLY

CLUTCH CONTROL AND LINKAGE REMOVAL , REPAIR, REPLACEMENT,

AND ADJUSTMENT .

TOOLS : Prybar

6-inch ruler

9/16-inch wrench (2)

Drift pin punch

3/4-inch wrench (2)

Pliers

Flat-tip screwdriver

SUPPLIES : Chalk, SS-C-266F

PERSONNEL : One

Truck parked, engine off, handbrake set, wheels

EQUIPMENT CONDITION :

chocked.

Preliminary Procedures.

(1) Take off accelerator linkage. Refer to para 4-29.

(2) On trucks with transmission power takeoff, tell direct support mainte-

nance to take off power takeoff.