Replacement (Basic Type) .
Do not put fingers between front mounting support (1)
and bracket ( 2) . Jack may slip , causing severe injury
Put upper resilient mount (3) between front mounting support (1) and
bracket (2) and aline holes.
Put flat washer and bolt (4) through front mounting support (1) , upper
resilient mount ( 3) , and bracket ( 2) as shown.
Using jack, carefully lower front of engine.
Put lower resilient mount (5) and flat washer (6) on bolt (4).
Using' 3/4-inch wrenches, screw on and tighten locknut ( 7).
Follow-on Maintenance Action Required:
Close hood and both side panels. Refer to TM 9-2320-209-10.
END OF TASK