INSTALLING THE MOUNTING PLATE TO THE CARGO BED COVER - continued

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0014 00

UNIT MAINTENANCE

Have a second person hold the left side mounting plate section (1) in position and install a total of four

5/16-18 UNC x 1 inch long carriage bolts (8) up through the mounting plate (1) and the CBC carrier

mounting angle (7).

Install one 5/16 inch flat washer (9) over the end of the bolt and against the surface of the carrier

mounting angle (7) followed by a 5/16 inch lockwasher (10) and 5/16 UNC hex nut (11) for each of the

remaining bolts.

Tighten all hardware by hand but do not tighten securely at this time.

Installing the right side (passenger or curbside) mounting plate section. Install the right side

mounting plate section (12) in the same fashion as for the left mounting plate section detailed previously.

Be sure to butt the ends of the side section with the additional weather stripping against the end of the

front and rear section.

Press the right side mounting plate section up into position and align the holes on the mounting plate with

the holes on the carrier mounting angles.

Have a second person hold the right side mounting plate section in position and install a total of four 5/16-

18 UNC x 1 inch long carriage bolts up through the mounting plate and the CBC carrier mounting angle.

Install one 5/16 inch flat washer over the end of the bolt and against the surface of the carrier mounting

angle followed by a 5/16 inch lockwasher and 5/16 inch UNC hex nut for each of the remaining bolts.

Once all four sections of the mounting plate assembly have been installed, tighten all hardware securely.

0014 00-8