Quantcast WINCH HYDRAULIC OIL RESERVOIR

 

Click here to make tpub.com your Home Page

Page Title: WINCH HYDRAULIC OIL RESERVOIR
Back | Up

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
OIL FILTERS - LO-9-2320-386-120018
Up
/.5ton/LO-9-2320-386-12 2-1/2 Ton 6x6 M44A3 ESP Vehicles: Truck Cargo Fixed Side: M35A3; Truck Cargo Dropside: M35AC Manual
LO 9-2320-386-12
NOTES (Contd)
Do not overfill transmission. Internal trans-
mission component damage will result.
(3) If transmission oil level is low, add oil through filler tube. Return dipstick to filler
tube, tighten dipstick handle, and wipe away any spilled oil.
c. When AOAP laboratory support is not available, change oil every 24,000 miles
(38,616 km) or 24 months, whichever occurs first.
11. WINCH HYDRAULIC OIL RESERVOIR
Weekly check to ensure oil level is visible in sight glass. If low, remove cap and replenish oil
to dot on sight glass. Every 12,000 miles (19,308 km) or 12 months, whichever occurs first,
remove drainplug from reservoir and drain oil. Always install drainplug after draining. Refill
reservoir to dot on sight glass 39 qt (36.9 L).
12.
FRONT WHEEL UNIVERSAL JOINTS AND STEERING KNUCKLE BEARINGS
Every 12,000 miles (19,308 km) or annually, whichever occurs first, remove plug from
universal joint housing, fill to level of plug opening, and reinstall plug. Remove lugs on each
side of steering knuckle, and fill to level of plug opening through upper and lower steering
knuckle bearings. Do not disassemble.
13. WHEEL BEARINGS
Every 6,000 miles (9,654 km) or six months, whichever occurs first, remove, clean, dry,
repack, and install wheel bearings.
14. FRONT SPRING SHACKLES
CAUTION
Wipe fittings clean before servicing to prevent
damage to shackle pins and bushings.
Every 3,000 miles (4,827 km) or three months, whichever occurs first, lubricate with GAA
until  grease appears between shackle pin and bushing at both ends of spring shackle. If
shackle pin does not accept GAA, remove pin. Clean and inspect shackle pin and bushing.
Replace if necessary.
15. OILCAN POINTS
Every 1,000 miles (1,609 km) or monthly, whichever occurs first, lubricate hinges and
latches, transfer case linkage, accelerator cable, accelerator linkage, highbeam selector
switch, parking brake lever, and spare tire carrier boom roller with seasonal grade
OE/HDO.
16. DO NOT LUBRICATE
Springs, alternator, water pump, or shock absorbers.
PAGE 19 OF 20

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.